Cisco 200-355 Free Practice Questions

Question No: 3

Which type of management tasks can be completed on a Cisco WLC remotely from a wireless client?

A. All management and configuration tasks can be performed from a wireless client except for using debug commands.

B. In the default configuration, no management or configuration is possible through the GUI or CLI on the Cisco WLC.

C. The default configuration of the Cisco WLC allows only CLI access and then only the use of show commands, so no configuration is possible.

D. All management and configuration tasks, except uploads from and downloads to the Cisco WLC, are permitted.

View Answer

Question No: 4

Which purpose does a spectrum analyzer serve during a site survey?

A. Detect and measure RF energy on a frequency.

B. Identify and monitor rogue APs in the environment

C. Capture and save RF traffic to analyze it offline.

D. Generate a list of interference reports.

View Answer

Question No: 5

Which information on the Monitoring page of a Cisco WLC verifies that the wireless network is operational?

A. In the Access Point Summary section, the All APs number in the Up column is the same as in the Total column.

B. In the Client Summary section, the Current Clients number is positive.

C. In the Controller Summary section, the 802.11b/g Network State is shown as Enabled.

D. In the Controller Summary section, the CPU Usage number is positive.

View Answer

Question No: 6

Which statement about the impact of configuring a single SSID to support TKIP and AES encryption simultaneously is true?

A. The overhead associated with supporting both encryption methods degrades client throughput significantly.

B. Some wireless client drivers might not handle complex SSID settings and may be unable to associate to the WLAN.

C. This configuration is unsupported and the Cisco Wireless Control System generates alarms continuously until the configuration is corrected.

D. This configuration is common for migrating from WPA to WPA2. No problem is associated with using this configuration.

View Answer

Question No: 7

What three characteristics are components of mobility anchoring? (Choose three.)

A. enabled as a global setting

B. enabled on a per WLAN basis

C. restricts clients to a specific subnet

D. client traffic is tunneled to predefined WLC(s)

E. only one mobility anchor is allowed per WLAN

F. acts as master controller for a mobility group

View Answer

Question No: 8

Which CLI command is used on a Cisco WLC to troubleshoot mobility, rogue detection, and load-balancing events?

A. debug dot11

B. debug capwap all

C. show dot11 details

D. show capwap details

View Answer

Question No: 9

To implement a more secure means of communication for voice and data, what technology successfully resists interference by utilizing a wider bandwidth than needed for the transmitting signal?

A. Spread Spectrum

B. Microwave

C. Extended U-NII2

D. ISM Bands

View Answer

Question No: 10

Refer to the exhibit. In WCS, what Monitor submenu would provide the table shown?

A. Clients

B. Access Points

C. Controllers

D. Security

E. Alarms

View Answer

Question No: 11

A customer wants to analyze the data rates that are available to a corporate laptop in its wireless deployment. The customer wants a heat map that displays actual data and shows the data rates that are available to the client in different areas of its facility. When using AirMagnet Survey PRO, which type of survey provides the actual data rates?

A. virtual

B. predictive

C. passive

D. active

View Answer

Question No: 12

Which two statements about the results of the Cisco WCS version 7.0 client troubleshooting tool are true? (Choose two.)

A. Results of Layers 1 - 3 are provided.

B. Results of only Layers 2 and 3 are provided.

C. Results of Layers 4 - 7 are provided.

D. The tabulated results vary depending on the client type.

E. Results are provided in a fixed four-part tabulation.

F. Results are provided in a fixed six-part tabulation.

View Answer